What happens if iphone 4 gets wet

After disconnecting the cameras flex cable, you can lift it out. This is the final screw holding down the board. Gently lift the logic board out of the phone. You should be able to pop each tab up, do not use a lot of force to avoid permanently bending the tabs. Do this for the 4 plates that are removeable. There is one plate that is soldered on and can not be removed. Spray iRevive generously onto the logic board and then use the brush to scrub the entire board.

If you can not wait, you can use a blow dryer on the cool setting to speed up the process. Do not use a hot blow dryer. Once you are sure that the board is dry and all the water damage is removed, you can snap the plates back onto the board.

Replace the camera, flat screw and then the plate with the 5 screws holding it down. Also replace the vibrate motor in the top right corner and its 2 screws. Then reconnect the charging port flex cable and put the cover back on with the two screws to hold it down. Connect the antenna and then replace the screw to hold down the battery connector. Replace the bottom two screws with your pentalobe screw driver. Please wait Home Repairs iPhone Repair. Yes No. Character limit: Maximum character limit is Start a discussion in Apple Support Communities.

After we receive your trade-in you will get an email with a link you can use for the purchase. It's good for 7 days. If your iPhone comes into contact with water or another liquid and gets wet, resist the urge to panic while the liquid saturates the internal components. Instead, follow these simple steps in order to prevent lasting water damage to your iPhone:.

Remove your wet iPhone from the liquid and power off your device. Due to their conductive nature, water and other liquids short-circuit electronics. Do not power on your iPhone, charge it, or connect it to other devices without proper time to dry. Dry your iPhone with a soft, absorbent cloth and carefully wipe down the headphone jack and charge port.

Evaporating liquid with a heat source causes additional damage and is not recommended.